Toyota Dashboard Warning Lights Guide Performance Toyota Indicates a malfunction in:*the srs airbag system;*the front passenger occupant classification system; or*the seat belt pretensioner systemhave your vehicle. Repeat this procedure about 5 7 times. the key here is to get the timing right. afterwards, go ahead and start the car’s engine. check if the srs light has gone out. if the indicator light isn’t responding, try the following number of seconds: turn the key on, wait 7 seconds, then turn it off and wait 3 seconds.
Why Is My Toyota Srs Warning Light On Toyota Of Seattle Youtube The srs warning light indicates a problem with the airbags, front passenger occupant classification system, or the seat belt pretensioner system in the vehicle. this light will tell you if there is a problem with the airbags. when the vehicle begins, it usually comes on for a few seconds. the problem can be detected if the device remains active. Any of these issues will cause the srs light to come on. malfunctioning srs ecu – the ecu that controls the srs airbag system in most toyota is located within the central console. that position proved potentially troublesome, as the ecu may get flooded there. in most cases, this happens if the car has a leaking windshield or cracked heater. Corrosion in the sensors or connectors will also cause the light to come on. in rare cases, the srs control unit will go bad. a bad control unit requires either reprogramming or replacement. make sure that you have an experienced mechanic perform the repair to get your airbag system working properly again. To 4 seconds after disconnecting terminal tc. then, reconnect terminals tc and cg within 2 . to 4 seconds after the srs warning light comes . on, connect terminals tc and cg of the dlc3. (7) check if the srs warning light goes off within 2 . to 4 seconds after connecting terminals tc and . cg of the dlc3.
Comments are closed.