Toyota Sienna Service Manual Engine Oil Cooler 2gr о Toyota sienna service manual: installation. 1. install engine oil cooler. (a) clean the oil cooler contact surface on the cooler mounting. (b) install a new o ring to the oil cooler. (c) install the oil cooler assembly with the union bolt. torque: 68 n*m (693 kgf*cm, 50 ft.*lbf) install the 2 water by pass hoses with the bolt, 2 clamps, and 4. Toyota sienna service manual: engine oil cooler. toyota sienna service manual engine 2gr fe lubrication installation 1. install timing chain case oil seal (a.
Toyota Sienna Service Manual Installation Engine Oil Cooler 2gr Fe This potentially catastrophic engine issue affects a range of toyota highlander, venza, and sienna vehicles equipped with the optional tow package oil cooler. Page 28 em–27 2gr fe engine mechanical – engine assembly 34. disconnect engine wire (a) disconnect the engine wire from the engine room junction block. (1) remove the nut and separate the wire harness. (2) using a screwdriver, unlock the engine room j b. page 29 em–28 2gr fe engine mechanical – engine assembly 36. Only use clean engine oil. (a) place the lash adjuster into a container filled with engine oil. (b) insert sst's tip into the lash adjuster's plunger and use the tip to press down on the check ball inside the plunger. sst 09276 75010. Donut shaped thing under front exhaust manifold. ~$120 used, $700 new. be sure to get the huge bolt that holds it down, and a new large o ring for the bottom and new washer for the bolt head. 2 coolant lines that go to oil cooler. new are ~$30 and ~$20. not sure if t's or y's are needed somewhere.
Toyota Sienna Service Manual Installation Engine Oil Cooler 2gr Fe Only use clean engine oil. (a) place the lash adjuster into a container filled with engine oil. (b) insert sst's tip into the lash adjuster's plunger and use the tip to press down on the check ball inside the plunger. sst 09276 75010. Donut shaped thing under front exhaust manifold. ~$120 used, $700 new. be sure to get the huge bolt that holds it down, and a new large o ring for the bottom and new washer for the bolt head. 2 coolant lines that go to oil cooler. new are ~$30 and ~$20. not sure if t's or y's are needed somewhere. Engine front oil seal components. 9. remove crankshaft pulley timing chain case oil seal. 10. install timing chain case oil seal crankshaft pulley. 11. engine rear oil seal components. 12. remove drive plate and ring gear sub assembly. Lkq shows compatible engines from the avalon, rav4, etc., in addition to sienna. same issue here, 2011 sienna with the 2gr fe, 7 years old and only 51k miles on it. small seapage on the rear head gasket. dealer quoted me $2,800cad tx for replacing both gaskets, still waiting on my local shop for a price.
Comments are closed.