Replacing Hose O Rings Scuba Tech Tips S07e10 Youtube Replacing the o ring on regulator hoses is something you can do or your local dive shop. alec shows the tools and techniques needed to do this gear service . Aug 15, 2024. #1. i have a standard bcd inflator hose that came with a zeagle lazer bcd several years ago. i would like to know the size or description of the o ring which is up inside of the quick disconnect coupling. i'm told the o ring on the end that screws into the regulator first stage is a 011. the one inside the quick disconnect on the.
Easily Replace An O Ring Scuba Diving Maintenance For Beginners Apply only enough lube to make the elastomer shiny, and you can even wipe it clean with a lint free cloth after and it will probably still be sufficiently lubed. if possible, use an oxygen compatible lubricant like christolube. this is not just for oxygen nitrox compatibility these lubricants tend to outperform silicone greases. new hoses. Another cause is using the wrong size o ring. the fix a new o ring and a stronger hand on the yoke screw. abort the dive? only until you calm down. the leak — hose o rings. where at either end of any hose, between hose end fitting and whatever it screws into (first stage, second stage, bc inflator, spg, etc.). Did you know that early double hose regulators had no o rings? alec shares history, tools and tips to ensure you buy the correct scuba o ring.watch my "alec. Feed the new hose through the console, replace the swivel spool in the spg, then attach the spg to the end of the high pressure hose and tighten. pull the hose back through the console and fit the gage snugly into place. this may take a few minutes. do not use too much force or pull too hard on the hose. a bit of wiggling should suffice.
Comments are closed.