Practical Tips For Drawing Blood Visual Ly Pull the skin taut to anchor the vein. insert the beveled needle at a 15 to 30 degree angle into the vessel. once blood is seen in the tubing, connect the vacutainers or use a syringe to draw the needed amount. properly label the tubes (at the bedside) and send them to the laboratory for analysis. As the person drawing blood, it is important you know how to draw blood correctly. this includes sticking the vein correctly and using the proper tubes. for example, a cbc (complete blood count) will go into a lavender tube while a pt inr will be collected into a blue tube. note: some facilities require different tubes so always make sure you.
How To Draw Blood A Step By Step Guide Best practices in phlebotomy. this chapter covers all the steps recommended for safe phlebotomy and reiterates the accepted principles for blood drawing and blood collection (31). the chapter includes background information (section 2.1), practical guidance (section 2.2) and illustrations (section 2.3) relevant to best practices in phlebotomy. 1. place a warm pad or washcloth over the draw site. warmth causes the veins to dilate, making them easier to spot and stick. to heat up the veins, apply a warm compress over the draw site for 2 3 minutes, and be sure to disinfect the area with 70% alcohol afterwards (before you draw blood). [2]. Prep the venipuncture site by cleansing the area with an alcohol prep pad for 30 seconds and allow to air dry for 30 seconds. grab the patient’s lower arm (below site of puncture) firmly to draw the skin taut and anchor the vein from rolling. insert the needle at a 15 to 30 degree angle into the vessel. Step 6: draw blood. perform venipuncture using the following steps: place your thumb below the venipuncture site to retract the skin. be sure not to touch the venipuncture site or you will need to repeat the cleaning process. puncture the vein quickly and at a 15 to 30 degree angle, with the bevel of the needle pointing up.
How To Draw Blood A Step By Step Guide For Medical Professionals Prep the venipuncture site by cleansing the area with an alcohol prep pad for 30 seconds and allow to air dry for 30 seconds. grab the patient’s lower arm (below site of puncture) firmly to draw the skin taut and anchor the vein from rolling. insert the needle at a 15 to 30 degree angle into the vessel. Step 6: draw blood. perform venipuncture using the following steps: place your thumb below the venipuncture site to retract the skin. be sure not to touch the venipuncture site or you will need to repeat the cleaning process. puncture the vein quickly and at a 15 to 30 degree angle, with the bevel of the needle pointing up. Inspect your needle for defects. the end should have no obstructions or hooks that will restrict the flow of blood. 2. thread the needle into the holder. use the needle sheath to secure the needle in the holder. 3. tap any tubes that contain additives to dislodge the additives from the walls of the tube. 4. The information given here supplements that given in chapters 2 and 3. users of these guidelines should read chapters 2 and 3 before reading the information given below. this chapter covers background information (section 6.1), practical guidance (section 6.2) and illustrations (section 6.3) relevant to paediatric and neonatal blood sampling.
Comments are closed.