Nissan Rogue Service Manual Fluid Cooler Hose Removal And

Nissan Rogue Service Manual Oil Cooler Removal And Install Remove fender protector side cover. refer to ext 28, "fender protector : exploded view". remove fluid cooler hoses. installation. installation is in the reverse order of removal. caution: do not reuse hose clamp. securely install fluid cooler hose a clip to the radiator core support. refer to the followings when installing fluid cooler hoses. Hold the hose and can as high as possible and spray transmission cooler cleaner in a continuous stream into the cooler outlet hose until cvt fluid flows out of the cooler inlet hose for 5 seconds. insert the tip of an air gun into the end of the cooler outlet hose. wrap a shop rag around the air gun tip and end of the cooler outlet hose.

Nissan Rogue Service Manual Fluid Cooler Hose Removal And For warranty repairs on 2013 2015 rogue and rogue select vehicles, nissan ns 3 cvt fluid must be used. for customer pay repairs, nissan ns 3 cvt fluid or an equivalent is recommended. order nissan ns 2 and ns 3 cvt fluid through the nissan maintenance advantage program: phone: 877 nis nma1 (877 647 6621). 1) take out air intake remove 3 screws, wiggle out the top air intake. 2) pull the cylindrical air intake coming from the fender area. 2) take out bumper 4 push pins on top, 4 push pins on bottom, 2 x t20 torx and 2 x 10 mm (not exactly sure on the size) on each side. 3) take out battery. Yes: remove the left front wheel and then partially remove the left front fender protector to gain access to the cvt fluid cooler and then proceed to step 3. refer to the electronic service manual (esm), section ext – exterior for information. no: proceed to step 5. place an oil drain pan under the cvt fluid cooler. Then turn it all the way. clamp both of the coolant hoses attached to the cvt fluid cooler to prevent coolant loss. figure 6. remove “bolt a” and loosen “bolt b” for the water hose bracket in figure 7. remove the spring clamps from the cvt fluid cooler water hoses and then remove both hoses from the cvt fluid cooler.