How To Reset A Maintenance Light On A 2016 Toyota Sienna Youtube Reset your maintenance light on your toyota sienna.turn key to on.press trip button until trip a is shown. release button.turn key to off.hold trip button in. How to reset the maintenance light on a 2016 toyota sienna after an oil change.
2016 Toyota Sienna Maintenance Required Light Reset Youtubeођ In this video, i'll show you how to reset maintenance light on toyota sienna. my toyota is 2014 but this process works on many other years and models of toyo. To reset the toyota sienna maintenance light, first, turn on the ignition without starting the engine. then, locate and press the odo trip meter until the odometer displays. turn off the ignition, hold the odo trip button, turn on the ignition again, and hold until zeros display. Press the odometer button on the dash until the total miles are shown. turn the key to the “off” position. press and hold the “odometer trip reset” button. while holding, turn the key to the “on” position. continue holding the “odometer trip reset” button until the “maintenance required” light blinks several times and turns off. 1. turn your ignition to the “i” position. put your keys in the ignition and turn them to the first position, usually marked as “i”. [1] this will turn the electricity on in your car, but not the engine. 2. click the odometer reset button until it says “trip a,” then hold it. change the odometer so it reads “trip a.”.
Maintenance Light Reset Toyota Sienna 2015 2016 Youtube Press the odometer button on the dash until the total miles are shown. turn the key to the “off” position. press and hold the “odometer trip reset” button. while holding, turn the key to the “on” position. continue holding the “odometer trip reset” button until the “maintenance required” light blinks several times and turns off. 1. turn your ignition to the “i” position. put your keys in the ignition and turn them to the first position, usually marked as “i”. [1] this will turn the electricity on in your car, but not the engine. 2. click the odometer reset button until it says “trip a,” then hold it. change the odometer so it reads “trip a.”. Insert your key into the ignition and turn it to the first or "on" position, but don't start the engine. push and hold the trip reset button on the dashboard until "trip a" is displayed on the. Push and hold the trip meter reset button on the dashboard and turn your key to the second position. continue holding the trip meter button for 10 seconds. the light should flash, you may hear a beet, and the light will go out. once the light goes out, release the odometer button and fully start the car. if you notice the lights are still on.
Comments are closed.