How To Replace The Thermostat On A Ford Exploer 91 2001 Ford Car Do you need to replace the thermostat the ford explorer 1991 to 2001 but don't know where to start? this video tutorial shows you step by step how to do it!o. In this video i will be showing you how to remove and install the thermostat housing that comes with the thermostat for your ford explorer with a 4.0l. how t.
How To Replace Your Thermostat Ford Explorer 4 6l V8 2002 2005 Youtube 1997 2001 ford explorer 4.0l sohc v6 thermostat replacement. not to be confused with the 4.0l ohv v6. *be very careful that you do not knick the lip on the. Good write up, but yeah x2 on the post the images as imaging post. some people will tell you that you can use the gaskets maker on the edges that its better for it. they used to make a cork board gaskets for it, since the age of the ex is old theyve stopped making a lot of the gaskets, especially now there is 655 (o rileys says so lol) different kinds of gasket maker. Pull out the old thermostat. seat the new thermostat inside the housing in the same position as the old one, spring side facing into the engine. install new gasket over the thermostat. reattach the thermostat housing cover and the radiator hose. reinstall the air cleaner duct if removed earlier. fill the radiator with reserve or new coolant. Pry the thermostat housing off the engine block. pull the thermostat out of the housing. remove the old gasket and discard. slide the new thermostat into the housing the same way the old one came out. install the new o ring seal in the housing. coat the housing with a thin layer of silicone gasket maker. allow the gasket maker to dry.
How To Replace Thermostat Housing 2001 2005 Ford Explorer Sport Trac Pull out the old thermostat. seat the new thermostat inside the housing in the same position as the old one, spring side facing into the engine. install new gasket over the thermostat. reattach the thermostat housing cover and the radiator hose. reinstall the air cleaner duct if removed earlier. fill the radiator with reserve or new coolant. Pry the thermostat housing off the engine block. pull the thermostat out of the housing. remove the old gasket and discard. slide the new thermostat into the housing the same way the old one came out. install the new o ring seal in the housing. coat the housing with a thin layer of silicone gasket maker. allow the gasket maker to dry. I'm sure someone with more knowledge of the 2000 v8 will jump in. explorer, sport trac, mountaineer & aviator replacing thermostat on explorer 4.6 v8 2000 explorer, with triton 4.6 v8 engine. all seems fine, temperature is in normal range but there is no heat. the upper heater hose never gets even warm. i think it's the failed t stat. Allow the gasket maker to dry. slide the bolts into the thermostat housing, then line the bolts up to the bolt holes on the block. slide the housing down the bolts until it touches the block. turn the bolts in by hand to get them started. tighten the bolts to 89 inch pounds of torque. reinstall the upper radiator hose.
Comments are closed.