Discover Excellence

How To Replace Radiator Hose On Toyota Rav4 Youtube

how To Replace Radiator Hose On Toyota Rav4 Youtube
how To Replace Radiator Hose On Toyota Rav4 Youtube

How To Replace Radiator Hose On Toyota Rav4 Youtube We have a toyota rav4 in the garage with the 3.5 v6 that needs to have the upper and radiator hoses replaced. this repair should be the same for the 2006 201. Do you hear a different engine noise? is it slightly a whining sound? then you may have a radiator hose going bad. they deteriorate over time. dry wrought. t.

how To Replace Your 2006 2012 toyota rav4 radiator hoses youtube
how To Replace Your 2006 2012 toyota rav4 radiator hoses youtube

How To Replace Your 2006 2012 Toyota Rav4 Radiator Hoses Youtube How to replace the radiator hoses and coolant on a 2006 2012 toyota rav4, 4 cylinder. radiator hoses degrade from the inside out, making pending failure diff. 1. drain the radiator. place a large pan under the radiator. locate and loosen the drain petcock at the bottom corner of the radiator. close and tighten the petcock after the coolant has drained. some radiators do not have a petcock. in this case, remove the lower radiator hose to drain the radiator. 2. Step 3: locate the egr valve hose and disconnect it from engine bay. step 4: connect overfill funnel to the radiator fill slot. step 5: keep adding coolant to the funnel until you see coolant come out of the egr value hose, and then reattach the hose. Take these little push clips out. what you do is you push down just a little bit on the clip and just slide it out. just use a pocket screwdriver or a pick. just grab that panel, slide it out. before we take this radiator support bracket off, it's a good idea to mark this.

how To Replace radiator 05 16 toyota rav4 youtube
how To Replace radiator 05 16 toyota rav4 youtube

How To Replace Radiator 05 16 Toyota Rav4 Youtube Step 3: locate the egr valve hose and disconnect it from engine bay. step 4: connect overfill funnel to the radiator fill slot. step 5: keep adding coolant to the funnel until you see coolant come out of the egr value hose, and then reattach the hose. Take these little push clips out. what you do is you push down just a little bit on the clip and just slide it out. just use a pocket screwdriver or a pick. just grab that panel, slide it out. before we take this radiator support bracket off, it's a good idea to mark this. In this video, i'm going to show you how to replace the coolant reservoir on this 2010 toyota rav4. if you need parts for your vehicle, click the link in the description and head over to 1aauto . from underneath the vehicle, we need to remove this panel right here. this one was pretty much falling off. there really wasn't much holding it on. Brian eslick from how to automotive howtoautomotive takes you step by step through the process of replacing the upper radiator hose with vent.

Comments are closed.