Heavily Distressed Dresser Turned Into Bathroom Vanity Distressed

Heavily Distressed Dresser Turned Into Bathroom Vanity Distressed Hold the upper drawer face in place on the dresser. position a brace in the corner where the face meets the dresser frame. tack the brace to the frame and drill a pilot hole through the brace into the drawer face. secure the face with 1 inch wood screws. install the remaining braces and slide the lower drawer into place. Vintage dresser bathroom vanity. ditch the builder grade vanity and replace it with a vintage dresser with lots of character. a vessel sink is a perfect choice for your dresser turned vanity makeover. it sits on top so it doesn't take precious space away from the drawers that can be used for necessary storage.

Reclaimed Dresser Turned Distressed Bathroom Vanity Https Www Step 7. cut out in back of vanity for water lines and plumbing. i slid my vanity in place against the water lines and the plumbing pipe and marked the back of the vanity. i tipped it on it’s front, made a starter hole with my drill and then used my jig saw to cut out circles for the water lines and plumbing pipe. step 8. In the end, the dresser, sink, and faucet all together cost less than $130 – a total steal for a custom vanity. how to turn an antique dresser into a bathroom vanity. the first thing i did to my own dresser was paint it. in retrospect, this wasn’t a great plan. i ended up having to do tons of touch ups to the paint later on. If using a round or oval sink, evenly space 4 to 6 holes around circle. insert jigsaw into one hole and cut to next hole. repeat until entire piece is cut out. test fit sink and make any adjustments necessary. if refinishing dresser top, do it after hole is cut, so finish isn't marred. 5. cut and fit sink. measure the top of the dresser and mark with a pencil where the sink is going to go. make sure it's forward enough to accommodate the faucets and any pipework. after marking out and checking your measurements for pipes and faucets, get a drill and make a hole large enough to fit a jigsaw blade.

Bathroom Vanity From Antique Dresser We Find Restore Convert Paint If using a round or oval sink, evenly space 4 to 6 holes around circle. insert jigsaw into one hole and cut to next hole. repeat until entire piece is cut out. test fit sink and make any adjustments necessary. if refinishing dresser top, do it after hole is cut, so finish isn't marred. 5. cut and fit sink. measure the top of the dresser and mark with a pencil where the sink is going to go. make sure it's forward enough to accommodate the faucets and any pipework. after marking out and checking your measurements for pipes and faucets, get a drill and make a hole large enough to fit a jigsaw blade. Choosing the right sink for the vanity. in order to turn a dresser into a vanity you need to determine what type of sinks you want to use. you have the option to go with a vessel type sink that essentially sits on top of the dresser or an undermount option. 5. cutting holes for the sink. Measure twice {or twenty times} and cut once. using the decision that we made earlier to leave 1 2 inch of the sink exposed, the mr. cut the top of the dresser to fit our sink. to do this, he used a bit that attaches to your drill and cuts out a circle on both the back corners.