Detroit Diesel Series 60 Coolant System Seananon Jopower Hey guys today we take a look at a dd60 or detroit diesel 60 series. it’s building pressure in the coolant system. in this video i’ll show you how to diag th. Also used a dd reman head through freightliner dealer. i was told to avoid aftermarket heads. some have been found to be milled too much. detroit kits don’t come with rod bearings. aftermarket kits do. bearings are another $350, plus core deposit. detroit does research on old bearings and heads, so i’ve been told by an engineer at detroit.
Detroit Diesel Series 60 Coolant System Seananon Jopower On a good working system, coolant system pressure should not exceed 10 psi. series 60's ddec 5 egr engines are bad about fretting between the cylinders, and usually require salvage sleeves (liners cut till fretting is gone) if the head shows the same signs, it will need to be replaced. Flush it out with a hose and tap water. you are light years ahead of the game by using the red or yellow. just did an inframe on my 60 series last year at 900,000 miles. cooling system and counterbores looked like brand new. engine has never had anything but red coolant in it. hulld, apr 1, 2018. #6. Series 60 cooling system components. the cooling system consists of the following components: water pump. pressure control cap. thermostat. engine cooling fan. coolant filter and conditioner. radiator or heat exchanger. charge air cooler raw water pump. 2004 detroit 60 14l coolant reservoir system is being over pressurized by something other than the air compressor, which is bypassed. but the block test test.
Comments are closed.