Autolisp Divide Polyline Segment Autocad Tips It is to put a figure as a rectangle or similar, then specify a side and that it is divided into new figures according to the cut, according to the distances. for example, in a closed rectangle (polyline) choose a side. (which measures 7 for example) put 3 and that is divided into two rectangles with side 3 and one with side 1. Then, use the sd command in subdivide.lsp [attached] to break the polyline into a specified number of equal length pieces, which will split it halfway between each of the blocks you just added to it. or, the other two step approach: first, use sd to split it into equal segments.
Autolisp Divide Polyline Segment Autocad Tips 02 04 2022 09:32 am. you may be able to use subdivide.lsp with its sd command, >here<. see the comments at the top, particularly about adding the point objects. however, it doesn't do a fixed segment length, but either a quantity of segments you specify or a maximum segment length you specify [it calculates the minimum number of segments so. To use it, follow the steps below: firstly, type on the command line divide. autocad will ask to select an object to divide. here you can select the polyline spline line object that will be divided. the next step will be to either to enter the number of the segments or [block]. if you want to use a block object hit “ b “, if an autocad. Type pdmode change to 3. now type divide and select the pline3 for number of segments type 3 or whatever number. you want to divide the line into. this does not actually break the line but places a. node along the line at the specified break number in this case 3. you could then use the break command and break the pline to the node that is. And i repeat this following given segment length. see example as attached. white object represent my polyline. cross divide our object into segments. yellow lines are the perpendicular on my object (make these fexed length yellow lines using lisp). thanks in advance! —sam. quote.
Comments are closed.