2002 Ford Escape 3 0 Engine Code P1409 Youtube What is the cost to diagnose the code? labor: 1.0. to diagnose the p1409 ford code, it typically requires 1.0 hour of labor. the specific diagnosis time and labor rates at auto repair shops can vary based on factors such as location, vehicle make and model, and engine type. Vacuum line.
2002 Ford Escape 3 0 Engine Code P1409 Youtube To fix the automobile fault code p1409, follow these steps: 1. check the possible causes mentioned above. 2. visually inspect the wiring harness and connectors related to the fault code. 3. look for any damaged components. 4. check for broken, bent, pushed out, or corroded pins in the connectors. Disconnect the egr vacuum regulator solenoid electrical connector. key on engine off, verify b voltage at terminal 1, circuit 100 wh rd wire. if the voltage is not correct repair the circuit. if the voltage is correct continue to the next step.3. verify the egr vacuum regulator solenoid resistance between terminals 1 & 2 is 26 40 ohms. Ford mechanic: ron. the common caused for the code p1409 to set on your 2002 escape is not usually a failing egr valve but instead a failing egr vacuum regulator (evr) and or the connection to it. you can check the evr resistance first to see if it is in fact failing. check the resistance of the egr vacuum regulator (evr) looking for 26 40 ohms. Escape p1409. im getting this code back i changed egr soleniod then iac valve then cleaned the dpfe senor then put and new gasket behind the egr valve and replaced most of the vacum hose and this code will not go away so now what to i dont wanna keep throwing parts at it although i feel what i have done have done so far was a good idea cause.
What Is P1409 Engine Code Quick Guide 49 Off Ford mechanic: ron. the common caused for the code p1409 to set on your 2002 escape is not usually a failing egr valve but instead a failing egr vacuum regulator (evr) and or the connection to it. you can check the evr resistance first to see if it is in fact failing. check the resistance of the egr vacuum regulator (evr) looking for 26 40 ohms. Escape p1409. im getting this code back i changed egr soleniod then iac valve then cleaned the dpfe senor then put and new gasket behind the egr valve and replaced most of the vacum hose and this code will not go away so now what to i dont wanna keep throwing parts at it although i feel what i have done have done so far was a good idea cause. 133,000 miles. i have a trouble code of p1409. i have replaced my egr vacuum regulator solenoid and cleared the code but the code came back in 20 minutes. i have checked the voltage of both wires going into the connector for the egr vacuum regulator solenoid and both test at 12 volts. i tested the voltage of the opposite end of the connector. Note: if dtc p1409 was output in key on engine off (koeo) or key on engine running (koer) self test, go to he110 to diagnose present fault. disconnect pcm. key on. measure voltage between egrvr and pwr gnd circuits at the pcm harness connector. voltage must read greater than 10.5 volts.
Comments are closed.